How To Use Your Sleep Mode Pro Mask

Step 1: Setting Up Your Mask...

How to unwrap the Velcro tip, and adjust the head band
How to access the control unit and adjust the speaker position
How to charge the mask via USB

Step 2: Turning On & Using Your Mask...

How to turn the mask on
How to connect to your devices via Bluetooth
How to set the sleep timer (30mins, 60mins or 120mins)
How to listen to the built-in Sleep Sounds

Step 3: Cleaning Your Mask...

Step 4: Troubleshooting...

1. Controller Buttons Not Working...

If you find that the buttons on the controller aren't working correctly, you may need to re-center the control unit behind the buttons so they are aligned properly...

2. Can't See The LED Status Lights...

The LED status lights are quite small so make sure the ambient room light isn't too bright as it's easier to see them in a darkened room.

Also, try adjusting the position of the control unit behind the buttons as re-aligning the control unit will make it easier to see the LED status lights too.

3. Charging The Mask

To charge the mask, simply unzip the top of the mask and connect the micro USB charging cable.

You can charge the mask via the USB port on your computer, or via a USB power adapter (not included.)

When charging, the LED status light will turn red, and then after charging for around 2-3 hours it will turn to blue when finished.

Please note however, that the mask cannot be used while charging.